Attic hatch or door.
Attic insulation paper side up or down.
The upshot here is that if you put the kraft paper on the wrong side and it gets wet it won t trap moisture.
So if you re installing insulation in an attic that doesn t have any used faced insulation and put the paper side down toward the ceiling.
The vapor barrier is flammable and according to the manufacturer s label on the insulation the vapor barrier should be installed against the floor.
Also on the graph is the permeance of polyethylene.
The moisture will get the insulation wet and reduce its effectiveness.
Dont know about your location but here a ceiling installation calls for no vapor barrier.
We are purchasing a used home soon but the inspection report says that the attic insulation paper side is facing down into the crawl space and should be removed replaced since the paper side states that it is flammable.
Then you hang drywall over it all.
Pull down stair or ladder.
Foil insulation is a radiant barrier and it works by.
Make sure the first layer you put down on the floor of the.
The warmer air on one outer side of the wall causes water to build up along the colder inner side.
The right barrier will block the moisture from reaching the insulation.
Use a zippered insulated tent to keep the enclosure draft free attic tent at 7 attic cover insulator 120.
Add weatherstripping around the perimeter and a sweep to the door of a walk up attic.
Always have the paper toward the living area which in the case of an unfinished attic insulating attic floor would be paper face down.
If you put it on the right side where the humidity is it s not much of a vapor retarder.
The wetter it gets the better it dries.
Fiberglass batts insulation is installed in the crawl space with the paper facing exposed.
It is a fire hazard when left exposed and can trap moisture in the insulation.
When using insulation that has either paper or plastic facing that moisture barrier faces outward toward the attic space.
Even if the attic space is unheated it typically is warmer than the.
Fuzzy side faces away from you paper towards you.
Paper backed insulation is cut to fit betwen the studs or rafters and has little flaps on either side to secure the insulation w staples.
It can also cause mold rot and other problems in the wall.